Several Factors Affecting the Output of Impact Crusher

A general understanding of the factors affecting the production capacity of impact crusher. Generally speaking, there are many factors that affect the production capacity of impact crusher. Generally speaking, there are so many factors in five aspects. This article will describe these five factors and put forward the corresponding solutions.

1. Hardness of the material: the harder the material is, the more difficult it is to make sand, and the more serious the wear of the equipment. The speed of sand production is slow and the capacity is low. Therefore, we need to pay attention to the selection of materials.

2.Composition of the material: the more fine powder contained in the material before the impact crusher, the more it affects the sand making, because the fine powder is easy to adhere to affect the transportation. Therefore, the material with more fine powder content should be screened once in advance. The fine powder is screened from the material as far as possible, so as not to affect the normal work of the impact crusher.

3. Fineness of the material after crushing of impact crusher: fineness requirements are high, that is, the finer the material is, the smaller the sand capacity is. This aspect should be specified according to specific requirements. If there is no special requirement, the fineness of the material is generally set to medium fine.

4. Viscosity of the material: that is, the greater the viscosity of the material, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the sand making chamber in the Yuhong impact crusher. If it cannot be cleaned in time, it will affect the working efficiency of the impact sand making machine, and may also affect the normal work of the impact sand making machine in serious cases. Therefore, when choosing the material, we must pay attention to the viscosity of the material is not easy to be too large.

5. Material humidity: that is, when the moisture contained in the material is large, the material is easy to adhere in the impact sand making machine, and it is easy to cause blockage in the process of feeding and conveying, resulting in the reduction of sand making capacity. To solve this problem, first of all, the humidity of the material should be strictly controlled when the material is selected. If the humidity of the selected material is too large, sunshine or air drying can be used to reduce the percentage of moisture in the material.

<<Previous： What is the difference between silica powder and talcum powder?
<<Next：none